This unit is used to allow a Fork Truck operator to deliver loads to or pick up loads from a Power Conveyor while maintaining load integrity. This Station is also utilized when loads are delivered by Pallet-sleeve Forks. This is a modular, self-contained Fork Truck Entry Station with powered rollers and pendant-switch activated Jog Forward controls, allowing easily installation into a new or existing plant layout. The standard unit is 8' long with a 16-1/2" wide center strand. The Over-All Width and widths of the two (2) outside strands depend upon the width of the conveyor the unit meets up with.
Standard Widths Available | ||||
BF | 60" | 72" | 84" | 96" |
OAW | 66" | 78" | 90" | 102" |
Standard Stations are designed for a typical 9" wide by 6" high x 5' long pallet sleeve that is utilized for load retrieval and delivery.
Individual Electrical Control Panels are provided for existing installations.
Knurled Rollers provided for the powered Center-Strand aid in conveying loads.
Drive: 1 hp totally enclosed industrial rated 1750 rpm gear-motor with reversing capability. Drive package located within and under the device.
Optional Features:
- A Positive Run Photoeye can be included on the downstream end of the center strand.
- An Overhead Pendant-switch can also be provided for jog forward and reverse control.
- One end of the base plate can include a 90 degree angle to be embedded into the floor (requires saw cut or trench by customer). The 3" x 3" angle will be field welded to the base plate at the time of installation.
Speed: 45 or 60 fpm
Preassembly: Unit is wired at the factory.
Unit Height: 12" TOR level.
Capacity: 5,000 lbs. maximum.
Voltage: System voltage is 230/460 volt, 3 phase, 60 hertz with 115 volt, single phase control voltage.
Back to Products.